Verboom / Road construction

Asphalt under control.

From planning to opening.

Measure inside the asphalt layer, see when the rolling window closes, and record the whole job automatically. One platform for job planning, the paving crew and quality assurance.

The film · 1:08 · From asphalt weather to the record

Why in the layer

What machines measure, and what we add.

We do not replace infrared measurement; we add to it, and read it in. Infrared sees where the surface is cold. A sensor in the layer sees how warm it is there, and for how long. The surface cools faster than the core: in wind or cold the top is already too cold while the layer inside can still be rolled, or the other way round.11 The record shows them side by side.

Now, on the machine

The surface

Where
On top, over the whole lane
When
Once per spot, or per roller pass
What you see
Where it is cold
Tied to
The machine, and its make
Added, in the layer

A fixed point in the layer

Where
In the layer or beneath it, at a position and depth you choose
When
Continuously: from heating or paving until the road is open
What you see
How warm it is there and how fast it cools, against the window of your mix
Tied to
The job, with a record in the Verboom Platform
Built on the RAW

Works with the RAW, and in Germany with the ZTV.

The platform calculates with the rules your work is judged by: the Dutch Standaard RAW Bepalingen by CROW, section 81.22.03.12 No interpretation of our own of "good weather", but the check from the contract.

81.22.03
The weather check from the RAW,
per hour and per mix
5 °C
No laying below it;
for porous asphalt air ≥ wind + 5
1 m
The wind at 1 m above the ground,
where the RAW measures14
KNMI
The weather log measured,
with its source
What it delivers

Less guessing, less paperwork.

Less uncertainty when planning

Plan on the chance per hour instead of on one weather report. You see which day has the widest window, and move in time.

The rolling window in view

The crew sees how long the layer can still be rolled, on the phone or on a traffic light beside the job.

Sections you can compare

The same set-up in every section, so each section next to the other: where was it colder, where did it take longer.

Less manual work for the record

Weather log, temperatures, loads and machine reports go automatically into one job record, with the source of every value.

Sensorbox and set-up

Fixed positions, the same in every section.

One Sensorbox per section beside the job, with the measuring points in fixed positions across the cross-section: in the middle of the lane, on the longitudinal joint, at the free edge, and where needed in the layer below. The platform suggests the positions from the job; you decide.

BM-4122 measuring points per box

The standard for asphalt: the middle of the lane and the edge or the joint.

BM-4133 measuring points per box

For a third point: the bottom of a thick layer, a bridge deck, or middle, joint and edge.

Every minuteduring the job

Via LTE-M or wifi. Anything that does not get through is stored and sent later.

Roads

Plan a job with us.

A new surface course, a night with low-temperature asphalt, a bridge deck? Tell us which job, which layer and which mix. We set the job up in the platform, suggest the set-up and bring the boxes. Afterwards we go through the job record together.

Emailsales@verboom.com Call+31 182 37 98 60
Bring alongThe job, the layer and the mixwhich paver and roller you use, and what you want to know

Sources

  1. Bijleveld, Miller, De Bondt and Dorée, Too hot to handle, too cold to control, Eurasphalt & Eurobitume 2012: the surface cools faster than the middle of the layer; the middle can still be too hot while the surface is already too cold.
  2. CROW, Standaard RAW Bepalingen (the Netherlands), 81.22.03: measure the temperature and wind speed on site, at 1 m above ground; no paving below 5 °C; for porous asphalt and thin surface courses air at least wind + 5; for two-layer porous asphalt 1 April to 1 November and limits for wind and temperature.
  3. KNMI, Hourly weather data of the Netherlands (daggegevens.knmi.nl): temperature, hourly mean wind at 10 m and precipitation per station. The wind at 1 m follows from the logarithmic wind profile for open terrain.